Snow Performance Stage 3 EFI 2D Map Progressive Water Injection Kit
$729.99
$1,020.84
Water Meth Kits
California Not legal for sale or use in California on any pollution-controlled motor vehicle. This part has no CARB Executive Order; it is intended for off-road or competition use only.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
Specifications
- Brand
- Snow Performance
- Part number
- SNO-310
- Category
- Forced Induction › Water Meth Kits
- Shipping weight
- 8.4 lb
Specs are taken from the manufacturer listing. Confirm fitment for your car before ordering.
Details
The Snow Performance Stage 3 Boost Cooler® brings true 2D mapped water-methanol injection delivery to your EFI (electronic fuel injected) and forced induction (turbocharged/supercharged) vehicle. The Stage 3 creates a 2D injection map based off boost and fuel injector pulse width to deliver a extremely accurate amount of water-methanol when the engine needs it most. Bringing fuel injector pulse width into the mix allows the injection curve to be extended past specific boost points for greater range/control. None invasive, the Stage 3 Boost Cooler® controller is designed to mount on the steering column or the dash so no additional gauge pods need to be purchased and functions as a boost gauge, water-meth controller and fuel system monitor all in one! Proven to reduce the air inlet temperature by up to 100 degrees and increase octane by 25 points for maximum HP and cooling . Comes with adjustable Stage 3 water-meth controller, 1/4" High Temp Nylon line and easy to install quick-connect fittings.
- Cleans all carbon build up out of your motor
- Reduce air intake temps out too 100 degrees
- Two-dimensional injection map
- Increase octane by 25 points
- Built in boost gauge
- New nozzle design
- Lower EGTS
Fitting available at the shop — ask about installation.
